Freestanding street rig

Set up time: 30mins
Take down time: 20minutes
Height: 7 meters
Ground space/foot print: 5.5 metres x 7.5 meters
This can rig be erected on any area which is reasonable flat and 8meters away from open power lines.
This rig can be set up to the side of a main stage, or to the side of a 'pitch' then moved by two people into the 'show zone'. It will take ten minutes to level the rig before the performance.
Ballast needed: 4 x 40kg of builders sand which is available from all hardware stores.

Screw down rig

Set up time: 1 hour
Take down time: 30 minutes
Height: 6, 8, or 10 metres
Ground space/foot print: 12 metres across x 8 metres deep
Vertical supports comprised of two metre units of Aluminium tube.
2/3 guy ropes on each upright ( 4/6 in total).
Bolts into ground. 10mm dyna bolts into tarmac/concrete.

Crane rig

For working load limit of 600kg .
4 metre spreader bar.
Six guy ropes.
Dyna Bolts into concrete.
Eight tonne crane.
Foot print is adaptable pending area used.
4 metres to 8 metres sides.
8 metres to 12 metres front.

Technical Requirements for installing aerial equipment in venues.

I can also work on other rigs, architecture, trees and in buildings pending safety and rigging assessment. I prefer to do all my own rigging but am happy to work with other riggers.

Static Trapeze.

Minimum height: 5 metres
Bearing capacity of points: 350 kg per point
Three Points each 55cm apart.

Aerial Silks

Minimum Height: 7 metres
Bearing Capacity of one point: 1000kg

Bearing Trapeze

Minimum Height: 7 metres
Bearing Capacity of points: 600kg per point
Three Points each 55cm apart.

Bearing Aerial Silks

Minimum Height: 7 metres
Bearing Capacity of one point: 1200 kg